My 11 X5 35i went into limp mode this morning after running w/o issues. About 2 days later on hard acceleration it seems like my car just ran out of power- my MHD showed rail pressure at 70psi (!) which on acceleration its usually north of 3,000psi. So we replaced that and the code went away. printable degree wheel 2011 BMW 335i and I just had a code 2bf8 rail pressure sensor signal stuck permanently. Last week I posted an experiment fitting a warscroll into a standard 2.5"x3.5" playing card sleeve. Official release of the unofficial Warscroll Card Template. ace hardware shims what to say when a girl asks to hang out. e36freak92 BMW Specialist - 95 M3, 99 M3 DME does not recognize this and thinks the sensor is stuck. Rail sensor ambient fault conditions usually show low side fuel pressure being measured. Yes, from my experience, it’s usually a failing HDP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |